LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1990 >> S15 Jimmy RWD, Automatic, 700R4/MD8 >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Rear Axle Bearing & Seal >> Installation

Rear Axle Bearing & Seal: Installation

  1. Using Handle (J-8092) and Bearing Installer (J-23765), install bearing in axle housing until bearing installer bottoms against shoulder of axle housing. Lubricate bearing with axle lubricant.
  2. Using Seal Installer (J-23771), install seal until it is even with surface of axle housing. Install axle shaft and "C" lock. Pull axle shaft outward to ensure "C" lock seats in side gear.
  3. Install NEW pinion shaft lock bolt. Tighten lock bolt to 25 ft. lbs. (34 N.m). Install differential cover and new gasket. Refill drive axle with lubricant.
scientia non olet · About LEMON Manuals