LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1990 >> Jimmy Full Size V8-350 5.7L >> Repair and Diagnosis >> Transmission and Drivetrain >> Drive Axles, Bearings and Joints >> Axle Shaft Assembly >> Service and Repair >> Chevrolet Full Floating >> Axle Shaft

Axle Shaft

REAR AXLE SHAFT

1. Remove bolts that attach axle shaft flange to wheel hub.
2. Tap on flange with a rawhide mallet to loosen axle shaft, then remove axle shaft by twisting shaft with locking pliers.
3. Thoroughly clean both axle shaft flange and end of wheel hub. Any lubricant on these surfaces tends to loosen axle shaft flange bolts.
4. Place a new gasket over axle shaft and position axle shaft in housing so that shaft splines enter differential side gear. Position gasket so that holes are in alignment and install flange-to-hub attaching bolts.
scientia non olet · About LEMON Manuals