LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1990 >> Forward Control 7.4 N, Automatic, 400/M40 >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> DISC & DRUM (C, G, K, P, R & V Series) >> Removal & Installation >> Front Disc Rotor - 2WD Models >> Installation

Front Disc Rotor - 2WD Models: Installation

  1. Clean and pack wheel bearings. Install rotor and hub assembly. Install outer bearing, washer and nut. Tighten nut to 12 ft. lbs. (16 N.m) while rotating rotor and hub assembly. This seats bearings.
  2. Back off nut until it just begins to loosen. Finger-tighten nut. Back off nut until hole in spindle aligns with hole in nut (DO NOT  back off more than 1/2 of a flat). Install new cotter pin, bend over ends and ensure ends will not contact grease cap when installed. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals