LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1990 >> Forward Control 6.2 J, Automatic, 475/M40 >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Disc Brake System & Drum Brake System) >> Removal & Installation >> Rear Brake Rotor >> Removal (9 3/4" & 10 1/2" Full-Floating Axle)

Removal (9 3/4" & 10 1/2" Full-Floating Axle)

WARNING: This page does not describe the selected car, but rather 35 other vehicles, including the 1992 Pontiac Trans Sport, 1992 Oldsmobile Silhouette, 1992 Oldsmobile Bravada, 1992 GMC Yukon, and 1992 GMC Vandura Special. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Remove brake caliper (DO NOT disconnect brake hose). See REAR BRAKE CALIPER under REMOVAL & INSTALLATION . Remove bolts from end of axle shaft.
  2. Lightly tap axle shaft flange with soft hammer to loosen shaft. Grip rib on axle shaft flange with locking pliers. Twist axle shaft to start shaft removal. Pull axle shaft from axle housing.
  3. Bend lock washer tab away from lock nut. Using Wheel Bearing Nut Wrench (J-2222-C), remove lock nut. Remove lock washer. Remove adjusting nut and washer. Remove hub and rotor assembly.
scientia non olet · About LEMON Manuals