LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1990 >> Forward Control 6.2 J, Automatic, 475/M40 >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Disc Brake System & Drum Brake System) >> Removal & Installation >> Rear Axle Hub Bearings & Oil Seal (Full-Floating Axle) >> Removal (9 3/4" & 10 1/2" Axle With Disc Brakes)

Removal (9 3/4" & 10 1/2" Axle With Disc Brakes)

WARNING: This page does not describe the selected car, but rather 35 other vehicles, including the 1992 Pontiac Trans Sport, 1992 Oldsmobile Silhouette, 1992 Oldsmobile Bravada, 1992 GMC Yukon, and 1992 GMC Vandura Special. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove rear hub and rotor assembly. See REAR BRAKE ROTOR under REMOVAL & INSTALLATION . Using a long drift and hammer, drive out inner bearing race, inner bearing and oil seal from outboard to inboard side of hub.
  2. Remove retaining ring from inside of hub, inboard of outer bearing. Using Handle (J-8092) and Outer Bearing Race Remover/Installer(J-24426), drive out outer bearing race from outboard to inboard side of hub.
scientia non olet · About LEMON Manuals