LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1990 >> Forward Control 6.2 J, Automatic, 475/M40 >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Disc Brake System & Drum Brake System) >> Removal & Installation >> Rear Axle Hub Bearings & Oil Seal (Full-Floating Axle) >> Removal & Installation (12" Axle)

Removal & Installation (12" Axle)

WARNING: This page does not describe the selected car, but rather 35 other vehicles, including the 1992 Pontiac Trans Sport, 1992 Oldsmobile Silhouette, 1992 Oldsmobile Bravada, 1992 GMC Yukon, and 1992 GMC Vandura Special. However, it is still accessible from the selected car via links, so may be relevant.

Remove rear hub and rotor assembly. See REAR BRAKE ROTOR under REMOVAL & INSTALLATION . Note how outer bearing race is seated against retaining ring inside hub, on inboard side of race. See Figure. Hub bearing removal and installation procedure is not available from manufacturer.

scientia non olet · About LEMON Manuals