Condenser HVAC: Service and Repair

Figure 35-Condenser Replacement:

REMOVE OR DISCONNECT
1. Refrigerant from the system.
2. Grille and front-end panel.
3. Radiator bar support.
4. Inlet and outlet refrigerant lines.
5. Condenser (2).

INSTALL OR CONNECT
1. Condenser (2).Tighten mounting bolts to 27 Nm (20 lbs. ft.).
2. Refrigerant lines.
3. Radiator bar support.
4. Grille and front-end panel.
5. Refrigerant to the system.