Ignition Switch
- To remove ignition switch, steering column must be lowered, but it is not necessary to remove steering wheel. See Steering Column Removal in this Section. If steering is not removed from vehicle, support column before proceeding.
- Place ignition switch in "LOCK" position. If lock cylinder has already been removed, pull up on actuating rod of switch until it stops, then push down one detent. This will position switch in "LOCK" position. Remove two screws, then remove ignition switch.
- To install, switch and lock cylinder should be in "LOCK" position. With switch in correct position, install activating rod in switch. Install switch on column and tighten mounting screws. Install steering column and check system operation.
NOTE:
Use only specified screws as overlength screws may prevent a portion of column from compressing under impact.