Valve Arrangement
E-I-I-E-E-I-I-E-E-I-I-E (Front to rear)
- Remove distributor cap. Mark distributor housing at No. 1 and No. 6 rotor firing positions.
- With distributor rotor in the positions designated in Valve Adjustment table, adjust valves as follows: Loosen rocker arm adjusting nut until push rod lash (play) is felt. Tighten adjusting nut until all lash is removed. When lash has been removed, tighten adjusting nut 1 full turn to complete procedure.
VALVE CLEARANCE ADJUSTMENT
| Rotor Position | Adjust Int. Nos. | Adjust Exh. Nos. |
|---|---|---|
| No. 1 | 1, 2, 4 | 1, 3, 5 |
| No. 6 | 3, 5, 6 | 2, 4, 6 |