LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1981 >> Magnavan Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engines - 5.0L & 5.7L V8 Engines >> Crankshaft & Rod Bearings >> Main & Connecting Rod Bearings >> Connecting Rod Bearings

Connecting Rod Bearings

  1. Mark or ***rod cap to rod before removing rod cap nuts. With *** removed, remove rod cap and bearing. Push up on *** and rod assembly and remove bearing from rod. Inspe*** rings for wear or damage and replace as necessary.
  2. Check crankshaft rod bearing journal for *** round or taper conditions. If crankshaft is out-of-roun*** ers more than 0.001", crankshaft must be removed and*** for undersize bearings.
  3. Check bearing clearance using the Plastigage method. If clearance exceeds specifications, a 0.001" or 0.002" undersize bearing may be installed to obtain correct clearance. If clearance is still excessive, crankshaft must be removed and ground for undersize bearings. Connecting rod bearings are available 0.010" and 0.020" undersize.
  4. To install bearings, clean crankshaft journal and bearing surface in rod. Insert bearing halves in rod and cap. Lubricate journal and pull piston and rod assembly down, aligning bearing on journal. Install rod cap noting identification marks and evenly tighten rod nuts.
scientia non olet · About LEMON Manuals