LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1981 >> Magnavan Standard Trans >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Drive Axles - SPICER (DANA) Full-Floating Front & Rear Axles >> Removal & Installation >> Front Axle Shafts & Bearings >> Removal (Jeep "CJ" & Scrambler Models)

Removal (Jeep "CJ" & Scrambler Models)

  1. Raise vehicle and position on safety stands. Remove wheel and tire. Remove disc brake caliper. Remove drive flange cap from center off hub.
  2. Remove drive flange snap ring. Remove bolts securing drive flange to rotor hub. Remove drive flange using a suitable puller (J-25133 or equivalent).
  3. Straighten washer lip and remove outer lock nut. Remove washer, inner lock nut and bearing washer. Remove outer bearing and disc brake rotor.
  4. Remove disc brake caliper adapter and splash shield. Remove spindle nuts and remove spindle. Carefully pull out axle shaft and "U" joint assembly. Drive inner bearing and seal from hub.
scientia non olet · About LEMON Manuals