"G" Van Models With 4.1L (250") & 4.8L (292") Engines
- Disconnect battery cable and remove engine cover. Remove air cleaner and studs. Remove fan guard. Remove radiator upper supports. Raise vehicle.
- If vehicle is equipped with a standard transmission, perform the following steps before continuing: Disconnect clutch cross shaft from left front mount bracket. Remove transmission-to-bell housing upper bolt. Remove transmission rear mount bolts and install two 7/16" X 3" bolts. Raise transmission using jack and install 2" block between mount and crossmember.
- Remove starter and drain engine oil. Remove engine mount bolts. Raise engine sufficiently to insert wooden blocks between engine mounts and crossmember brackets.
- Remove flywheel splash shield or torque converter cover as applicable. Remove oil pan attaching bolts and remove oil pan.