Dodge & Plymouth
- Check power steering pump reservoir and fill with power steering fluid (MOPAR Power Steering Fluid). Allow fluid to remain undisturbed for 2 minutes. Leave reservoir cap off during operation.
- Start engine and run for ten seconds. Check fluid level and add fluid if necessary. Repeat procedure until fluid level remains constant. Raise front of vehicle and allow tires to clear floor. Start engine and run at 1500 RPM. Apply and release brakes several times, at the same time turn wheels back and forth, lock to lock. Turn off engine and check fluid level. Add fluid if necessary.
- Lower vehicle. Start engine and run at 1500 RPM. Apply and release brake pedal several times, at the same time turn front wheels back and forth, lock to lock. Turn off engine and check fluid level. Add fluid if necessary. If fluid level is low, repeat bleeding procedure. Place cover on reservoir.