LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1981 >> Forward Control 4.8L Eng VIN T, Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 4.1 L & 4.8L 6-Cylinder Engines >> Camshaft >> Camshaft Bearings >> Removal

Camshaft Bearings: Removal

  1. With oil pump and pan removed, drive out camshaft rear plug from block. Following manufacturers instructions for tool set (J-6098) remove center bearings first.
  2. Front and rear bearings are removed by assembling drive handle to tool set (J-6098) and driving bearings towards center of block.
scientia non olet · About LEMON Manuals