LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1966 >> I1500 Automatic Trans >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Drive Axles - DANA/SPICER Semi-Floating Axles >> Removal & Installation >> Rear Axle Shafts & Bearings >> Removal (Tapered Shaft End)

Removal (Tapered Shaft End)

  1. Raise vehicle and support with floor stands. Remove wheels. Remove cotter pin, nut, and washer securing hub to axle shaft. Using a suitable hub puller, remove hub and drum assembly (back off brake shoes if necessary). Disconnect hydraulic brake lines. Remove bolts and lift off seal retainer, bearing retainer, backing plate and shims.
    NOTE: Do not damage shims; retain them for reassembly.
  2. Using a slide hammer, remove axle shaft and bearing assembly.
    NOTE: Do not apply sharp blows to shaft; bearing damage could result.

    Use a suitable press to remove bearing and seal from shaft.

scientia non olet · About LEMON Manuals