LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2024 >> F-150 Lightning Pro >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center And Warning Chimes (Diagnosis & Testing - Removal Installation) >> General Procedures >> Seatbelt Minder Deactivating Activating

Seatbelt Minder Deactivating Activating

For information on Ford Color Coded Illustrations refer to OEM COLOR CODING

Seatbelt Minder Deactivating/Activating 

Deactivation 

WARNING: Before beginning any service procedure in this article, refer to Safety Warnings in HEALTH AND SAFETY PRECAUTIONS Failure to follow this instruction may result in serious personal injury.
NOTE: The driver Belt-Minder® is deactivated/activated independently. When deactivating/activating one seating position, do not buckle the other position.
NOTE: Clear any message center warnings that are present before and throughout the procedure.
NOTE: This procedure will only disable the audible  seatbelt minder. If the seatbelt buckle is fastened then unfastened while the vehicle is running, the seatbelt warning message will stay on and the seatbelt warning indicator will continue to flash until the warning system times out. It is not possible to clear the warnings. The My Vehicle screens cannot be navigated until the seatbelt warning system times out.
  1. Apply the parking brake before deactivating/activating the Belt-Minder®.
  2. Place the gearshift selector in PARK (P).
  3. Place the ignition in OFF.
  4. Close all vehicle doors, hood and tailgate.
  5. Unbuckle the seatbelt.
  6. Place the ignition in the RUN mode (do not start the engine).
  7. NOTE: This step must be completed within 30 seconds after placing ignition in RUN mode.
    NOTE: As confirmation of disabling or enabling the Belt-Minder®, the seatbelt warning indicator flashes 4 times, then illuminates solid.

    For the seating position to be disabled/enabled, buckle then unbuckle the seatbelt 5 times at a moderate speed, ending with the seatbelt in the unbuckled state. Allow the seatbelt indication display to illuminate red (unbuckled) and green (buckled) between each buckle/unbuckle state.

  8. Place the ignition in OFF.
  9. NOTE: Only the seatbelt warning chime will be deactivated. The seatbelt warning indicator and seatbelt display will continue to illuminate when the seatbelt buckle is unfastened.

    Start the engine and drive the vehicle with the applicable seatbelt buckle unfastened at a minimum speed of 10 km/h (6 mph) to confirm the seatbelt warning chime is deactivated or activated.

  10. After confirmation, the deactivation/activation procedure is complete.
scientia non olet · About LEMON Manuals