Side Obstacle Detection Control Module C (SODCMC): Removal

WARNING: This page is about a different car, the 2024 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removal steps in this procedure may contain installation details.

On both sides.Remove the 2 screws.
Torque

: 1.7 Nm

Courtesy of FORD MOTOR COMPANY
Remove the front bumper upper cover trim panel.Using a flat blade screwdriver release the locking tabs.Use the General Equipment: Flat Headed Screw Driver

Courtesy of FORD MOTOR COMPANY
1. Remove the screws.
  Torque
  
  : 3.2 Nm
2. Release the tabs and position the SODCMC bracket aside.
Courtesy of FORD MOTOR COMPANY
1. Disconnect the electrical connector.
2. Release the tabs and remove the SODCMC.

Courtesy of FORD MOTOR COMPANY