Diagnostic Trouble Code (DTC) Chart
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
Diagnostic Trouble Code Chart
| Module | DTC | Description | Action |
|---|---|---|---|
| ABS | C0049:01 | Brake Fluid Level: General Electrical Failure | GO to PINPOINT TEST K: THE BRAKE WARNING RTT (RECONFIGURABLE TELLTALE) INDICATOR IS ALWAYS ON |
| ABS | C0049:7B | Brake Fluid Level: Low Fluid Level | GO to PINPOINT TEST K: THE BRAKE WARNING RTT (RECONFIGURABLE TELLTALE) INDICATOR IS ALWAYS ON |
| BCM | B1178:01 | Boot/Trunk Ajar Switch: General Electrical Failure | GO to PINPOINT TEST O: THE TAILGATE AJAR WARNING INDICATOR IS ALWAYS ON |
| IPC | B1380:09 | Steering Wheel Switch Pack: Component Failure | GO to PINPOINT TEST AN: THE MESSAGE CENTER IS NOT OPERATING CORRECTLY |
| IPC | U0100:00 | Lost Communication With ECM/PCM "A": No Sub Type Information | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0102:00 | Lost Communication with Transfer Case Control Module: No Sub Type Information | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0103:00 | Lost Communication With Gear Shift Control Module "A:" No Sub Type Information | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0111:82 | Lost Communication With Battery Energy Control Module "A": No Sub Type Information | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0121:00 | Lost Communication With Anti-Lock Brake System (ABS) Control Module "A": No Sub Type Information | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0137:00 | Lost Communication With Trailer Brake Control Module: No Sub Type Information | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U013F:82 | Lost Communication With Pedestrian Alert Control Module: Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0151:00 | Lost Communication With Restraints Control Module: No Sub Type Information | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U019B:82 | Lost Communication With Battery Charger Control Module "A": Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0212:00 | Lost Communication With Steering Column Control Module: No Sub Type Information | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0212:82 | Lost Communication With Steering Column Control Module: Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0232:00 | Lost Communication With Side Obstacle Detection Control Module "A": No Sub Type Information | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0233:00 | Lost Communication With Side Obstacle Detection Control Module "B": No Sub Type Information | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U023A:00 | Lost Communication With Image Processing Module "A": No Sub Type Information | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U023A:82 | Lost Communication With Image Processing Module "A": Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0241:00 | Lost Communication With Headlamp Control Module "A": No Sub Type Information | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0253:00 | Lost Communication With Accessory Protocol Interface Module: No Sub Type Information | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0293:00 | Lost Communication with Hybrid/EV Powertrain Control Module: No Sub Type Information | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0293:82 | Lost Communication With Hybrid/EV Powertrain Control Module: Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BO: LOST COMMUNICATION WITH A MODULE |
| IPC | U0401:00 | Invalid Data Received from ECM/PCM A: No Sub Type Information | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0401:82 | Invalid Data Received from ECM/PCM A: Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0401:86 | Invalid Data Received from ECM/PCM A: Signal Invalid | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0405:56 | Invalid Data Received From Cruise Control Module: Invalid/Incompatible Configuration | GO to PINPOINT TEST BQ: INVALID DATA RECEIVED - INVALID/INCOMPATIBLE CONFIGURATION |
| IPC | U0415:00 | Invalid Data Received from Anti-Lock Brake System (ABS) Control Module "A": No Sub Type Information | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0415:82 | Invalid Data Received from Anti-Lock Brake System (ABS) Control Module "A": Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0420:82 | Invalid Data Received from Power Steering Control Module "A": Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0424:00 | Invalid Data Received From HVAC Control Module: No Sub Type Information | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0424:81 | Invalid Data Received From HVAC Control Module: Invalid Serial Data Received | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0424:82 | Invalid Data Received From HVAC Control Module: Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0428:82 | Invalid Data Received From Steering Angle Sensor Module: Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0431:82 | Invalid Data Received From Body Control Module "A": Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0438:82 | Invalid Data Received From Trailer Brake Control Module: Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0452:81 | Invalid Data Received From Restraints Control Module: Invalid Serial Data Received | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U049C:82 | Invalid Data Received From Battery Charger Control Module "A": Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0533:00 | Invalid Data Received From Side Obstacle Detection Control Module "A": No Sub Type Information | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0533:56 | Invalid Data Received From Side Obstacle Detection Control Module "A": Invalid/Incompatible Configuration | GO to PINPOINT TEST BQ: INVALID DATA RECEIVED - INVALID/INCOMPATIBLE CONFIGURATION |
| IPC | U0534:00 | Invalid Data Received From Side Obstacle Detection Control Module "B": No Sub Type Information | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0534:56 | Invalid Data Received From Side Obstacle Detection Control Module "B": Invalid/Incompatible Configuration | GO to PINPOINT TEST BQ: INVALID DATA RECEIVED - INVALID/INCOMPATIBLE CONFIGURATION |
| IPC | U053B:82 | Invalid Data Received From Image Processing Module A: Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0542:82 | Invalid Data Received From Headlamp Control Module "A": Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U057D:82 | Invalid Data Received From Off-Board Charger Control Module: Alive/Sequence Counter Incorrect/Not Updated | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U0594:00 | Invalid Data Received From Hybrid/EV Powertrain Control Module: No Sub Type Information | GO to PINPOINT TEST BP: INVALID DATA RECEIVED |
| IPC | U2100:00 | Initial Configuration Not Complete: No Sub Type Information | GO to PINPOINT TEST BR: U2100:00 |
| IPC | U3000:04 | Control Module: System Internal Failures | GO to PINPOINT TEST BS: U3000:04 OR U3000:46 |
| IPC | U3000:46 | Control Module: Calibration/Parameter Memory Failure | GO to PINPOINT TEST BS: U3000:04 OR U3000:46 |
| IPC | U3000:54 | Control Module: Missing Calibration | GO to PINPOINT TEST BS: U3000:04 OR U3000:46 |
| IPC | U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to PINPOINT TEST BT: U3003:16 |
| IPC | U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to PINPOINT TEST BU: U3003:17 |
| IPC | U300A:64 | Ignition Switch: Signal Plausibility Failure | GO to PINPOINT TEST BV: U300A:64 |
| PCM | P0071:00 | Ambient Air Temperature Sensor Circuit A Range/Performance: No Sub Type Information | GO to PINPOINT TEST AQ: THE OUTSIDE AIR TEMPERATURE DISPLAY IS INOPERATIVE OR INCORRECT |
| PCM | P0072:00 | Ambient Air Temperature Sensor Circuit A Low: No Sub Type Information | GO to PINPOINT TEST AQ: THE OUTSIDE AIR TEMPERATURE DISPLAY IS INOPERATIVE OR INCORRECT |
| PCM | P0073:00 | Ambient Air Temperature Sensor Circuit A High: No Sub Type Information | GO to PINPOINT TEST AQ: THE OUTSIDE AIR TEMPERATURE DISPLAY IS INOPERATIVE OR INCORRECT |
| SCCM | B1380:11 | Steering Wheel Right Switch Pack: Circuit Short To Ground | GO to PINPOINT TEST AN: THE MESSAGE CENTER IS NOT OPERATING CORRECTLY |
| SCCM | B1380:13 | Steering Wheel Right Switch Pack: Circuit Open | GO to PINPOINT TEST AN: THE MESSAGE CENTER IS NOT OPERATING CORRECTLY |
| SCCM | B1380:4A | Steering Wheel Right Switch Pack: Incorrect Component Installed | GO to PINPOINT TEST AN: THE MESSAGE CENTER IS NOT OPERATING CORRECTLY |
| SCCM | B1380:96 | Steering Wheel Right Switch Pack: Component Internal Failure | GO to PINPOINT TEST AN: THE MESSAGE CENTER IS NOT OPERATING CORRECTLY |
| SCCM | B1380:9E | Steering Wheel Right Switch Pack: Stuck On | GO to PINPOINT TEST AN: THE MESSAGE CENTER IS NOT OPERATING CORRECTLY |