Pinpoint Test Am: The Compass Is Inoperative
- Normal Operation and Fault Conditions
See Compass Display. REFER to: Message Center - System Operation and Component Description
If the compass direction message is missing or invalid for 5 seconds or less, the compass displays the last vehicle direction based upon the last known good compass display message received.
If the compass direction message is invalid or missing for more than 5 seconds, the IPC defaults the display to all dashes (---).
Possible Causes
- Communication concern
- APIM concern
- IPC
- AM1 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE APIM (ACCESSORY PROTOCOL INTERFACE MODULE) SELF-TEST
- Ignition ON.
- Using a diagnostic scan tool, perform the APIM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Information and Entertainment System No GO to AM2 - AM2 RETRIEVE THE RECORDED DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to the DIAGNOSTIC TROUBLE CODE (DTC) CHART . No
Guided Routine (APIM) only available in the on-line Service Information