Diagnostic Trouble Code (DTC) Chart
WARNING: This page is about a different variant/trim than selected.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| Module | DTC | Description | Action |
|---|---|---|---|
| PCM | P00FE:00 | EVAP System Tank Vapor Line Restricted/Blocked: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P043E:00 | EVAP System Leak Detection Reference Orifice Low Flow: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P043F:00 | EVAP System Leak Detection Reference Orifice High Flow: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0442:00 | EVAP System Leak Detected (small leak): No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0443:00 | EVAP System Purge Control Valve 'A' Circuit: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0446:00 | EVAP System Vent Control Circuit: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0451:00 | EVAP System Pressure Sensor/Switch 'A' Circuit Range/Performance: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0452:00 | EVAP System Pressure Sensor/Switch 'A' Circuit Low: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0453:00 | EVAP System Pressure Sensor/Switch 'A' Circuit High: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0454:00 | EVAP System Pressure Sensor/Switch 'A' Circuit Intermittent: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0455:00 | EVAP System Leak Detected - Large Leak: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0456:00 | EVAP System Leak Detected (very small leak): No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0457:00 | EVAP System Leak Detected (fuel cap loose/off): No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0460 | Fuel Level Sensor 'A' Circuit | GO to Pinpoint Test HX |
| PCM | P0461 | Fuel Level Sensor 'A' Circuit Range/Performance | GO to Pinpoint Test HX |
| PCM | P0462 | Fuel Level Sensor 'A' Circuit Low | GO to Pinpoint Test HX |
| PCM | P0463 | Fuel Level Sensor 'A' Circuit High | GO to Pinpoint Test HX |
| PCM | P0496:00 | EVAP System High Purge Flow: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P04EA:00 | EVAP System Small Leak Detected - Fuel Tank Side: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P04EB:00 | EVAP System Small Leak Detected - Fresh Air Side: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P04ED | EVAP System Large Leak Detected - Fresh Air Side | GO to Pinpoint Test HX |
| PCM | P04ED:00 | EVAP System Large Leak Detected - Fresh Air Side: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P04EE:00 | EVAP System Very Small Leak Detected - Fuel Tank Side: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P04EF:00 | EVAP System Very Small Leak Detected - Fresh Air Side: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P04F0:00 | EVAP System High Load Purge Line 'A' Performance: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P144A:00 | EVAP System Purge Vapor Line Restricted/Blocked: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P144B:00 | EVAP System Secondary Purge Vapor Line Restricted/Blocked: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P144C:00 | EVAP System Purge Flow Performance During Boost: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P1450:00 | Unable to Bleed Up Fuel Tank Vacuum: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P2401:00 | EVAP System Leak Detection Pump Control Circuit Low: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P2402:00 | EVAP System Leak Detection Pump Control Circuit High: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P2418:00 | EVAP System Switching Valve 'A' Control Circuit/Open: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P2450:00 | EVAP System Switching Valve 'A' Perfomance/Stuck Open: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P2451:00 | EVAP System Switching Valve 'A' Stuck Closed: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P24B9:00 | EVAP System Leak Detection Pump Pressure Sensor Circuit Range/Performance: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P24BA:00 | EVAP System Leak Detection Pump Pressure Sensor Circuit Low: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P24BB:00 | EVAP System Leak Detection Pump Pressure Sensor Circuit High: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P24BC:00 | EVAP System Leak Detection Pump Pressure Sensor Circuit Intermittent: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P24BE:00 | EVAP System Leak Detection Pump Switching Valve Control Circuit Low: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P24BF:00 | EVAP System Leak Detection Pump Switching Valve Control Circuit High: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P24C0:00 | EVAP System Leak Detection Pump Switching Valve Stuck On: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P24C1:00 | EVAP System Leak Detection Pump Switching Valve Performance/Stuck Off: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P260F | EVAP System Monitoring Processor Performance | GO to Pinpoint Test HX |
| PCM | P260F | EVAP System Monitoring Processor Performance | GO to Pinpoint Test HX |
| PCM | P260F:00 | EVAP System Monitoring Processor Performance: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P2DDA:00 | EVAP System Leak Detection Pump Performance/Stuck Off: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P2DDB:00 | EVAP System Leak Detection Pump Stuck On: No Sub Type Information | GO to Pinpoint Test HX |