Catalytic Converter - AWD: Installation

WARNING: This page is about a different variant/trim than selected.

Clean all exhaust connections before reassembly.
NOTE: The following step is only required if the components are being replaced with new items:

Install the isolator bracket assembly.

Courtesy of FORD MOTOR COMPANY
NOTE: Make sure that new gasket is installed:

Install a new gasket.

Courtesy of FORD MOTOR COMPANY
Position the catalytic converter in the vehicle.

Courtesy of FORD MOTOR COMPANY
Install the power transfer unit. Refer to: Power Transfer Unit .
NOTE: The nuts are only finger tight at this step.

Install the nuts.

Courtesy of FORD MOTOR COMPANY
NOTE: Make sure that new exhaust manifold nuts are installed:

Install the exhaust manifold nuts.

Torque

: 55 Nm

Courtesy of FORD MOTOR COMPANY
1. Tighten the lower bracket nut.
  Torque
  
  : 47.5 Nm
2. Tighten the PIA nut.
  Torque
  
  : 47.5 Nm
Courtesy of FORD MOTOR COMPANY
To install, reverse the removal procedure.
Check the exhaust system for leaks.