LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2024 >> Escape ST-Line Select >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation, Message Center And Warning Chimes (Description & Operation) >> Description And Operation >> Message Center >> Network Message Charts

Network Message Charts

Network Message Chart - Displays 

The data in each display is shown when the IPC receives messaged inputs from other modules on the CAN, unless the display data is controlled exclusively by the IPC. The IPC communcates on the HS-CAN3. If the originating module communicates on a network other than the HS-CAN3, the messaged signals are sent to the GWM first, then to the IPC.

Display Network Message Originating Module Originating CAN Receiving Module
Adaptive cruise control Cruise control set speed display PCM FD-CAN IPC
Adaptive cruise control gap distance display
Adaptive cruise control follow mode display
IPMA
Brake coach (HEV) Brake event data
Regenerative braking event level data
Regenerative event data
SOBDMC FD-CAN IPC
Clock Global clock data BCM HS-CAN1 IPC
Compass Compass direction APIM HS-CAN3 IPC
Digital speedometer Vehicle speed
Cruise control set speed display
PCM FD-CAN IPC
DTE /Average fuel economy Engine rpm data
Fuel flow volume display
Fuel range display
Odometer count
Power pack status
Vehicle speed
PCM FD-CAN IPC
Power pack status (HEV) SOBDMC FD-CAN IPC
Transport mode BCM HS-CAN1 IPC
Fuel level data IPC HS-CAN3 PCM
Electric vehicle (EV) range Hybrid mode status display SOBDMC FD-CAN IPC
Forward collision alert Forward collision warning indicator request IPMA FD-CAN IPC
High voltage battery state of charge Battery state of charge data BECM HS-CAN1 IPC
Lane centering aid system Traffic jam assist status IPMA FD-CAN IPC
Lane keeping system Hands off display
Lane keeping system status display
IPMA FD-CAN IPC
Music Audio source status ACM HS-CAN3 IPC
Navigation Distance to destination
Time to destination
Navigation route status
APIM HS-CAN3 IPC
Odometer Odometer count PCM FD-CAN IPC
Ignition status
Transport mode
BCM HS-CAN1
Outside air temperature Ambient air temperature filtered PCM FD-CAN HVAC module
Outside air temperature status HVAC module MS-CAN IPC
PRND Transmission gear display mode
Transmission gear display
PCM (gas) / SOBDMC (HEV) FD-CAN IPC
Vehicle speed PCM
Ignition status
Battery shed level request
Transport mode
BCM HS-CAN1
Startup/shutdown (HEV) Battery charge start and end time
Battery charge status display
SOBDMC FD-CAN IPC

Network Message Chart - Information-On-Demand Displays 

The information-on-demand displays are selected using the menu screens in the message center. The data in each display is shown when the IPC receives messaged inputs from other modules on the CAN, unless the display data is controlled exclusively by the IPC. The IPC communcates on the HS-CAN3. If the originating module communicates on a network other than the HS-CAN3, the messaged signals are sent to the GWM first, then to the IPC.

Information Display Network Message Originating Module Originating CAN Receiving Module
Auto stop/start Stop/start information on demand message request PCM FD-CAN IPC
Battery charge (HEV) Battery state of charge display BECM HS-CAN1 IPC
Electric efficiency (PHEV) Range per charge display SOBDMC FD-CAN IPC
Electric vehicle (EV) coach (HEV) Power level fill display
Power level threshold display
Power regeneration threshold display
SOBDMC FD-CAN IPC
Engine oil life Engine oil life PCM FD-CAN IPC
Engine oil life reset IPC HS-CAN3 PCM
Power distribution AWD lock torque request AWD module FD-CAN IPC
Vehicle speed PCM
Gear lever position
Wheel torque
PCM (gas) / SOBDMC (HEV)
Seatbelts (includes rear seatbelts Driver seatbelt buckle status
Passenger seatbelt buckle status
Driver rear seatbelt buckle status
Passenger rear seatbelt buckle status
Rear center seatbelt buckle status
RCM HS-CAN2 IPC
Tachometer (HEV) Engine active status SOBDMC FD-CAN IPC
Engine rpm data PCM
TPMS Tire pressure system status
Tire pressure placard data
BCM HS-CAN1 IPC
Trailer lighting Park lamp status BCM HS-CAN1 IPC
Trailer lamp connected
Trailer turn indicator status
Trailer lamp out
TRM MS-CAN

Network Message Chart - Warning Messages 

A warning message is displayed in the message center when the IPC receives messaged inputs from other modules on the CAN, unless the message is for a function exclusive to the IPC. The IPC communcates on the HS-CAN3. If the originating module communicates on a network other than the HS-CAN3, the messaged signals are sent to the GWM first, then to the IPC.

IPC Message Network Message Originating Module Originating CAN Receiving Module
Adaptive cruise control Adaptive cruise control message center request
Adaptive cruise control warning display
IPMA FD-CAN IPC
AWD fault and shift instructions AWD status display request AWD module FD-CAN IPC
Auto hold Auto hold message request ABS module FD-CAN IPC
Auto stop start Stop start message request PCM FD-CAN IPC
Automatic engine shutdown Engine idle shutdown status PCM FD-CAN IPC
BLIS / CTA system Side obstacle sensor status-left
Cross traffic alert brake warning-left
Cross traffic left sensor status
Side obstacle sensor status-right
Cross traffic alert brake warning-right
Cross traffic right sensor status
IPMA FD-CAN IPC
Brake system/Parking brake engaged/Brake fluid level low Brake (red) warning indicator request
Parking brake (red) indicator request
ABS module FD-CAN IPC
Brake fluid level status ABS module FD-CAN BCM
Brake fluid level low message request BCM HS-CAN1 IPC
Brake applied - power reduced Brake pedal applied message request PCM FD-CAN IPC
Charge port door ajar (PHEV) Charge port door open status SOBDM HS-CAN1 IPC
Power pack ready display SOBDMC FD-CAN
Charging system (12-volt) Battery low state of charge BCM HS-CAN1 IPC
Check fuel fill inlet (gas) / Check fuel door (HEV) Fuel fill inlet message display PCM FD-CAN IPC
Clear exit assist Clear exit assist message request IPMA FD-CAN IPC
Door, hood, liftgate ajar Driver door ajar status
Passenger door ajar status
Right rear door ajar status
Left rear door ajar status
Hood ajar status
Liftgate ajar status
BCM HS-CAN1 IPC
Electric parking brake Brake lamp request
Parking brake message request
Park brake (yellow) warning indicator request
ABS module FD-CAN IPC
Electric Vehicle (EV) fuel freshness (PHEV) Fuel maintenance mode display SOBDMC FD-CAN IPC
Electric Vehicle (EV) low engine use (PHEV) Low engine use message request SOBDMC FD-CAN IPC
Engine oil change minder Engine oil life PCM FD-CAN IPC
Engine on Driver door ajar status BCM HS-CAN1 IPC
Vehicle speed PCM FD-CAN
Power pack status
Transmission gear display
PCM (gas) / SOBDMC (HEV) FD-CAN
Engine over-temperature Engine coolant temperature data
Engine overheat indication request
PCM FD-CAN IPC
Factory/transport mode Factory mode
Transport mode
BCM HS-CAN1 IPC
Forward collision warning (pre-collision assist) Forward collision warning message request IPMA FD-CAN IPC
Front camera Camera front display status IPMA FD-CAN IPC
Head up display (HUD) Head up display message request HUD HS-CAN3 IPC
Hill start assist Hill start assist status ABS module FD-CAN IPC
Keypad code Keypad factory code BCM HS-CAN1 IPC
Lane centering aid Traffic jam assist message display
Traffic jam assist warning request
IPMA FD-CAN IPC
Lane keeping system Lane keeping system status display
Lane keeping system hands off display
IPMA FD-CAN IPC
Load shed (12-volt battery) Battery low state of charge BCM HS-CAN1 IPC
Low fuel Low fuel warning indicator request PCM FD-CAN IPC
Memory seat Memory command
Memory command drive status
DSM MS-CAN IPC
Neutral tow Neutral tow status PCM (gas) / SOBDMC (HEV) FD-CAN IPC
Parking aid Parking aid front status
Parking aid rear status
IPMA FD-CAN IPC
Passive key and immobilizer system Immobilizer message display BCM HS-CAN1 IPC
Power pack status PCM FD-CAN
Pedestrian alert (HEV) Pedestrian alert fault PACM HS-CAN1 IPC
Perimeter alarm Perimeter alarm chime request BCM HS-CAN1 IPC
Power child door locks/switch inhibit Lock system message request BCM HS-CAN1 IPC
Power steering EPAS failure PSCM FD-CAN IPC
Powertrain cooling Powertrain cooling message request PCM FD-CAN IPC
Ready to drive (HEV) Ready to drive display SOBDMC FD-CAN IPC
Remote start Remote start status BCM HS-CAN1 IPC
Reverse brake assist Rear brake assist alert display
Rear brake assist message request
IPMA FD-CAN IPC
Stability-traction control on/off Stability-traction control on/off message request ABS module FD-CAN IPC
Service AdvanceTrac Stability-traction control chime request ABS module FD-CAN IPC
Starting system Starting system message request PCM FD-CAN IPC
TPMS (fault and tire training status) Tire pressure system status BCM HS-CAN1 IPC
Trailer status Trailer lamp connected
Trailer turn indicator status
Trailer lamp out
Trailer battery charge
TRM MS-CAN IPC
Transmission Transmission service required PCM FD-CAN IPC
Transmission not in park Transmission gear message request
Transmission gear status
PCM (gas) / SOBDMC (HEV) FD-CAN IPC
Vehicle speed PCM FD-CAN
Driver door ajar status
Ignition status
Transport mode
BCM HS-CAN1
GSM gear message request GSM HS-CAN2
Vehicle plugged in (PHEV) Charge cord connection status SOBDMC FD-CAN IPC
Vehicle start inhibit (Over the Air [OTA] updates) Vehicle start inhibit message display GWM HS-CAN3 IPC