Muffler and Tailpipe - Plug-In Hybrid Electric Vehicle (PHEV): Removal

NOTE: Removal steps in this procedure may contain installation details.

1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: JACKING AND LIFTING .
2. 1. Remove and discard the clamp.
   2. Remove the isolator bracket studs and the muffler and tailpipe assembly.

   Courtesy of FORD MOTOR COMPANY

3. • NOTE: This step is only necessary when installing a new component.
     NOTE: Left-hand side shown, right-hand side is similar.

     Remove the isolator bracket studs.

     Torque

     : 25 Nm

   • Detach the isolator and remove the bracket.

Courtesy of FORD MOTOR COMPANY