LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2024 >> Escape ST-Line Hybrid >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling - 2.5L DURATEC - Hybrid (121KW 164PS) (BG) >> Removal And Installation >> Cooling Module >> Installation

Cooling Module: Installation

  1. To install, reverse the removal procedure.
  2. NOTE: Only use the specified material to lubricate the seals.

    Install and lubricate the new condenser fitting O-ring seals. Refer to: Specifications (412-00 Climate Control System - General Information - 2.5L Duratec - Hybrid (121kW/164PS) (BG), 2.5L Duratec - Hybrid (FHEV 148kW/201PS, PHEV 165kW/225PS) (BG)).

  3. Evacuate, leak test and charge the A/C system. Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging - 2.5L Duratec - Hybrid (121kW/164PS) (BG) .

    Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging - Hybrid Electric Vehicle (HEV), Vehicles With: R134A Refrigerant (412-00 Climate Control System - General Information - 2.5L Duratec - Hybrid (121kW/164PS) (BG), 2.5L Duratec - Hybrid (FHEV 148kW/201PS, PHEV 165kW/225PS) (BG)).

  4. Fill and bleed the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .
  5. Fill and bleed the electric powertrain cooling system. Refer to: Cooling System Filling and Bleeding (303-03 Electric Powertrain Cooling - 2.5L Duratec - Hybrid (121kW/164PS) (BG), 2.5L Duratec - Hybrid (FHEV 148kW/201PS, PHEV 165kW/225PS) (BG)).
  6. Check and fill the transmission fluid as necessary. Refer to: Transmission Fluid Level Check .
scientia non olet · About LEMON Manuals