Wastegate Control Valve Solenoid: Removal

1. If equipped, remove the engine appearance cover retainers, then remove the engine appearance cover.

   Courtesy of FORD MOTOR COMPANY

2. Disconnect the wastegate control valve solenoid, the ignition coil and the cylinder head temperature sensor electrical connectors.

   Courtesy of FORD MOTOR COMPANY

3. Disconnect the wastegate control valve solenoid hoses.Use the General Equipment: Hose Clamp Remover/Installer

   Courtesy of FORD MOTOR COMPANY

4. Remove the wastegate control valve solenoid retainers, then remove the wastegate control valve solenoid.

Courtesy of FORD MOTOR COMPANY