Pinpoint Test Ah: DTC P1001
WARNING: This page is about a different car, the 2024 Ford Transit-350 HD, 2024 Ford Transit-350, 2024 Ford Transit-250, and 2024 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.
- DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition PCM P1001:00 KOER Not Able to Complete, KOER Aborted: No Sub Type Information This DTC indicates the PCM aborted a self-test due to the vehicle not being in park or neutral, or the vehicle moving more than 5 mph during the self-test. Possible Causes
- Incomplete or incorrect PMI of the PCM.
- AH1
- Connect the diagnostic tool.
- Ignition ON.
- Retrieve and record all diagnostic trouble codes (DTCs). Repair any self-test or continuous memory diagnostic trouble codes (CMDTCs) first. Clear the DTC. Rerun the KOER self-test.
Is DTC P1001 still present?
Yes GO to AH2 No Fault may be intermittent or caused by low system voltage. - AH2 CARRY OUT THE PMI (PROGRAMMABLE MODULE INSTALLATION) FOR THE PCM (POWERTRAIN CONTROL MODULE)
- Ignition ON.
- Using a diagnostic scan tool, carry out the PMI procedure for the suspect module as directed by the diagnostic scan tool.
- CARRY OUT the transmission strategy download. REFER to: Transmission Strategy Download .
- Using a diagnostic scan tool, clear the diagnostic trouble codes (DTCs).
- Using a diagnostic scan tool, carry out the PCM self-test.
Is DTC P1001 still present?
Yes Update the PCM Calibration. CHECK OASIS for any applicable service articles: TSB, GSB (General service bulletin), SSM (Special service message) or FSA (Field service action). If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern,
INSTALL a new Powertrain Control Module (PCM).only available in the on-line service information RVC:
Generate RVC only works in single-step view Generate RVC requires VIN entry REFER to: Powertrain Control Module (PCM) .No The repair is complete.