Removal And Installation: Flexplate: Installation

WARNING: This page is about a different car, the 2024 Ford Transit-350 HD, 2024 Ford Transit-350, 2024 Ford Transit-250, and 2024 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.
- Install the flexplate aligning it with the offset hole and hand start bolts 5, 6, 7 and 8.
- Tighten the bolts 5, 6, 7 and 8 in sequence one turn at a time until the flexplate is snug against the rear face of the crankshaft.
- Install Special Service Tool: 303-103 (T74P-6375-A) Holding Tool, Flywheel.
- Torque the bolts 5, 6, 7 and 8 in sequence.
  Torque: 80 Nm
- Install the bolts 1, 2, 3 and 4 finger tight.
- Torque the bolts 1, 2, 3 and 4 in sequence.
  Torque: 80 Nm
- Remove Special Service Tool: 303-103 (T74P-6375-A) Holding Tool, Flywheel.
Courtesy of FORD MOTOR COMPANY
Install the transmission. Refer to: Transmission - LHD RWD . Refer to: Transmission - LHD AWD .
Use the Powertrain Control Module (PCM) Misfire Monitor Profile Correction routine in the diagnostic scan tool.
If a new flexplate was installed, road test the vehicle.