LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2024 >> E-Transit Cutaway >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (Automatic Transmission - 10-Speed Automatic Transmission - 10R80 (Symptom Diagnosis - Installation)) >> General Procedures >> Adaptive Learning Drive Cycle

Adaptive Learning Drive Cycle

WARNING: This page is about a different car, the 2024 Ford Transit-350 HD, 2024 Ford Transit-350, 2024 Ford Transit-250, and 2024 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM COLOR CODING

Programming 

NOTE: Perform the adaptive learning drive cycle on a level road surface.
  1. NOTE: Vehicles equipped with diesel engines use a TCM (transmission control module) that stores the transmission strategy information.

    Using the scan tool, clear the TCMKAM.

  2. Using the scan tool, clear the DTCs (Diagnostic Trouble Codes) and Transmission Adaptive Tables.
  3. Drive the vehicle until the engine and transmission reach normal operating temperature.
  4. Accelerate from a stop with light throttle (15%) ensuring that upshifts 1st through 8th occur at engine speeds between 1300-1600 rpm.
  5. Continue to accelerate (may apply slightly more throttle after 7-8 upshift at 32-38 mph (51-61 km/h) until you achieve 55 mph (88 km/h) and the 8-9 and 9-10 shifts complete.
  6. Brake very gently to a complete stop and hold foot on brake for five (5) seconds.
  7. Shift the transmission to Neutral. Wait 1 second.
  8. Shift the transmission to Reverse. Wait 2 seconds.
  9. Shift the transmission to Neutral. Wait 1 second.
  10. Shift the transmission to Drive. Wait 2 seconds.
  11. Repeat Steps 3 through 9 six additional times.
scientia non olet · About LEMON Manuals