LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2023 >> Mustang Mach-E Select, RWD >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center And Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test Bl: The Ready To Drive Chime Is Inoperative

Pinpoint Test Bl: The Ready To Drive Chime Is Inoperative

  1. Normal Operation and Fault Conditions 

    See Ready to Drive Chime. REFER to: Warning Chimes - System Operation and Component Description .

    Possible Sources 

    • Communication concern
    • SOBDMC
    • GWM
    • IPC

  2. BL1 CHECK THE SEATBELT WARNING CHIME OPERATION

    • Ignition OFF.

    • Ignition ON.

    • Monitor the seatbelt warning chime when the ignition switch is transitioned from OFF to RUN for 6 seconds.

    Does the seatbelt warning chime operate for approximately 6 seconds? 

    Yes  GO to BL2 
    No  GO to Pinpoint Test A 

  3. BL2 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Using a diagnostic scan tool, perform the IPC self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to Diagnostic Trouble Code (DTC) Chart 
    No  GO to BL3 

  4. BL3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Controller Area Network (CAN) Module Communications Network .
    No  DIAGNOSE all SOBDMC Diagnostic Trouble Codes (DTCs). REFER to the appropriate DTC Chart.
scientia non olet · About LEMON Manuals