Complete Repair
WARNING: This page is about a different car, the 2018 Ford F-350 Super Duty and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
After reassembling the transmission, several steps are required to properly restore the vehicle before returning it to the customer.
- Initial transmission fluid fill - this may be completed before the transmission is installed in the vehicle
- Clear adaptive tables - required for overhaul and when the solenoid body has been replaced
- Reset misfire monitor - required whenever the transmission has been removed
- Road Test until the transmission fluid is up to operating temperature, this is required to make sure transmission fluid cooler is full of transmission fluid
- Perform adaptive drive cycle - required if the adaptive tables were cleared
- Set transmission fluid level - transmission fluid is now at the correct temperature and that the transmission fluid cooler has been purged of air.
- Verify the repair resolved the concern - this is also known as the "post repair roadtest"