Seatbelt Minder Deactivating Activating

For information on Ford Color Coded Illustrations refer to OEM COLOR CODING

Seatbelt Minder Deactivating/Activating

Activation

WARNING: Before beginning any service procedure, refer to Safety Warnings. Failure to follow this instruction may result in serious personal injury.

NOTE: The driver and front passenger Belt-Minder® are deactivated/activated independently. When deactivating/activating one seating position, do not buckle the other position.

NOTE: Clear any message center warnings that are present before and throughout the procedure.

Apply the parking brake before deactivating/activating the Belt-Minder®.
Place the gearshift selector in PARK (P).
Place the ignition in OFF.
Close all vehicle doors, hood and liftgate.
Unbuckle the driver and the front passenger seatbelts.
Place the ignition in the RUN mode (do not start the engine).
Wait until the seatbelt warning indicator turns off (approximately 1 minute).
NOTE: Clear any message center warnings that are present before proceding with this step.

NOTE: This step must be completed within 30 seconds after the seatbelt warning indicator turns off (step 7).

Wait 5 seconds after the seatbelt warning indicator turns off then for the seating position to be disabled, buckle then unbuckle the seatbelt 4 times at a moderate speed, ending with the seatbelt in the unbuckled state. After this step the seatbelt warning indicator illuminates.
NOTE: As confirmation of disabling the Belt-Minder® (if currently enabled), the seatbelt warning indicator flashes 4 times per second for 3 seconds.

NOTE: As confirmation of enabling the Belt-Minder® (if currently disabled), the seatbelt warning indicator flashes 4 times per second for 3 seconds, followed by 3 seconds with the seatbelt warning indicator off, followed by another flash sequence of 4 times per second for 3 seconds.

After confirmation, the deactivation/activation procedure is complete.