Pinpoint Test Ca: The Ignition-Engine On Warning Chime Is Inoperative
- Normal Operation and Fault Conditions
Ignition-Engine On Warning Chime. REFER to: Warning Chimes - System Operation and Component Description
Possible Sources
- Interior lighting concern
- PRNDM/PRND indication concern
- BCM
- PCM
- SOBDMC (HEV)
- GWM
- IPC
- CA1 CHECK THE SEATBELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Unbuckle the driver seatbelt.
- Monitor the seatbelt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.
Does the seatbelt warning chime operate for approximately 6 seconds?
Yes GO to CA2 No GO to Pinpoint Test CI - CA2 CHECK THE DOOR AJAR INDICATION
- Open the driver door.
- Observe the door ajar warning RTT indicator.
Does the door ajar warning RTT indicator turn on with the driver door ajar?
Yes GO to CA3 No GO to Pinpoint Test N - CA3 CHECK THE PRNDM/PRND OPERATION
- Shift the transmission range selector through the ranges while observing the PRNDM/PRND indication.
Does the PRNDM/PRND indication match the selected transmission range?
Yes GO to CA4 No GO to Pinpoint Test AC - CA4 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to the IPCDTC Chart. No GO to CA5 - CA5 PERFORM THE BCM (BODY CONTROL MODULE) SELF-TEST
- Using a diagnostic scan tool, perform the BCM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to the Master DTC Chart. No GO to CA6 - CA6 PERFORM THE PCM (POWERTRAIN CONTROL MODULE) KOEO (KEY ON, ENGINE OFF) SELF-TEST
- Using a diagnostic scan tool, perform the PCMKOEO self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to the Master DTC Chart. No For gas engine, GO to CA8For HEV, GO to CA7 - CA7 PERFORM THE SOBDMC (SECONDARY ON-BOARD DIAGNOSTIC CONTROL MODULE C) SELF-TEST
- Using a diagnostic scan tool, perform the SOBDMC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Electric Powertrain Control No GO to CA8 - CA8 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Controller Area Network (CAN) Module Communications Network No DIAGNOSE an ignition concern. REFER to: Steering Wheel and Column Electrical Components