LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2023 >> Escape Base, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Parking Aid - Vehicles With: 180 Degree Camera 360 Degree Camera Parking Aid Camera >> Diagnosis And Testing >> Parking Aid >> Pinpoint Test(s) >> Pinpoint Test Y: Frozen Or Slow Screen Transitions Between Camera Views

Pinpoint Test Y: Frozen Or Slow Screen Transitions Between Camera Views

  1. Refer to PARKING AID for schematic and connector information.

    Normal Operation and Fault Conditions 

    REFER to: Parking Aid - System Operation and Component Description .

    Possible Sources 

    • IPMA

  2. Y1 CHECK FOR CORRECT IPMA (IMAGE PROCESSING MODULE A) OPERATION

    • Ignition OFF.

    • Disconnect and inspect the IPMA connectors.

    • Repair:

      • corrosion (install new connector or terminals - clean module pins)
      • damaged or bent pins - install new terminals/pins
      • pushed-out pins - install new pins as necessary

    • Reconnect the IPMA connectors. Make sure they seat and latch correctly.

    • Operate the system and determine if the concern is still present.

    Is the concern still present? 

    Yes  CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new IPMA. REFER to: Image Processing Module A (IPMA) .
    No  The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. ADDRESS the root cause of any connector or pin issues.
scientia non olet · About LEMON Manuals