LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2023 >> E-Transit Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 277 (Parking Brake And Actuation - Vehicles With: Electronic Parking Brake (EPB)) >> General Procedures >> Electronic Parking Brake (EPB) Service Mode Activation and Deactivation >> Deactivation

Electronic Parking Brake (EPB) Service Mode Activation and Deactivation: Deactivation

WARNING: This page is about a different car, the 2022 Ford Transit-350 HD, 2022 Ford Transit-350, 2022 Ford Transit-250, 2022 Ford Transit-150, and 2022 Ford E-Transit. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Carry out the following service mode deactivation procedure to activate the EPB system. The EPB system can also be activated using the diagnostic scan tool and following the on-screen instructions.
  1. Set the ignition to ON.
  2. Press and hold the accelerator pedal and place the EPB switch in the APPLY (upward) position. Continue to hold the accelerator pedal and the EPB switch.
  3. Firmly press the brake pedal for at least 1 second. Continue to hold the accelerator pedal and the EPB switch.
  4. Set the ignition to OFF then set the ignition to ON within 5 seconds  . Continue to hold the accelerator pedal and the EPB switch.
  5. NOTE: When service (maintenance) mode is deactivated, the yellow EPB indicator turns off and "Maintenance Mode" no longer displays in the message center.

    Release the accelerator pedal and the EPB switch.

  6. NOTE: The EPB system will fully apply and release the parking brake to guarantee sufficient air gap between the rear brake pads and brake disc.