Transmission Control Module (TCM): Installation

NOTE: Make sure that the terminals or pins/sockets of the transmission control module (TCM) and the TCM electrical connector are not bent or damaged.

Install the TCM and the bolts. Connect the wiring connector.

Torque: 89 lb.in (10 Nm)

Courtesy of FORD MOTOR COMPANY
NOTE: New units must be configured using the Programmable Modules Installation routine in the diagnostic tool.

Upload the module information from the diagnostic tool to the module using the Programmable Modules Installation routine. Use the General Equipment: Ford Diagnostic Equipment
Using the diagnostic tool, perform the TR Sensor Adaptive Learn and Clutch Adaptive Learn routines found in the TCM Adaptive Learning sub-menu.