Main Control Cover: Removal
- With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- Remove the air cleaner. Refer to: Air Cleaner .
-
- Remove the quick release couplings.
- Loosen the clamp.
- Remove the air cleaner tube.
-
NOTE: Make sure that the component terminals are not bent or damaged.
Disconnect the main control valve body connector and position aside the wiring harness.
- Remove the wiring harness retainers and position aside the wiring harness.
- Remove the wiring harness retainers and position aside the wiring harness.
- Remove the retainers and the underbody shield.
- Remove the nuts and remove the wiring harness retainer bracket.
- Remove the transmission main control cover studs.
-
NOTE: Be prepared to collect escaping fluid.
Remove the transmission fluid pan drain plug and allow the transmission fluid to drain.
- Remove the transmission main control cover studs.
- Remove the transmission main control cover studs.
- Remove the nut and position aside the ground wire.
-
NOTE: Be prepared to collect escaping fluid.
Remove the transmission main control cover studs and remove the transmission main control cover.