LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission - 6-Speed Automatic Transmission - 6F35 (2 Of 2)) >> Removal And Installation >> Transmission Internal Wiring Harness Frame >> Installation

Transmission Internal Wiring Harness Frame: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Position the transmission internal wiring harness frame on the guide pins and carefully install the transmission internal wiring harness frame by pushing it straight down into the solenoids. Use Special Service Tool: 307-636 Alignment Pins- Valve Body.
    GFD571575Courtesy of FORD MOTOR COMPANY
  2. Position and install the solenoid body assembly on the valve body.
    GFD571576Courtesy of FORD MOTOR COMPANY
  3. Install the transmission internal wiring harness frame screws.

    Torque: 31 lb.in (3.5 Nm)

    GFD571577Courtesy of FORD MOTOR COMPANY
  4. Connect the OSS sensor electrical connector.
    GFD571572Courtesy of FORD MOTOR COMPANY
  5. Connect the TR sensor electrical connector.
    GFD571578Courtesy of FORD MOTOR COMPANY
  6. Install the main control-to-cover seal.
    GFD571573Courtesy of FORD MOTOR COMPANY
  7. Install the main control cover. Refer to:Main Control Cover .
scientia non olet · About LEMON Manuals