Exhaust Gas Recirculation (EGR) Valve: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges that make leak paths. Use a plastic scraping tool to remove all traces of the exhaust gas recirculation (EGR) valve gasket.

NOTE: Make sure that the mating faces are clean and free of foreign material.

To install, reverse the removal procedure.

Material

: Motorcraft® Metal Surface Prep Wipes / ZC-31-B