Powertrain Control Module (PCM) DTC Chart
WARNING: This page is about a different variant/trim than selected.
| DTC | Description | Action |
|---|---|---|
| P06E4 | Control Module Wake-up Circuit Performance | RETRIEVE and RECORD all Control Module DTCs. If BCM DTC B10E5:11 or B10E5:15 is found, GO to Pinpoint Test C Clear all DTCs. RERUN the PCM self-test. If the DTC returns, CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If no TSBs address this concern, refer to PCM GUIDED ROUTINE TESTING |
| P06E9 | Engine Starter Performance | If the engine does not crank, GO to Pinpoint Test A |
| P162F | Starter Motor Disabled - Engine Crank Time Too Long | This DTC sets in the PCM when the engine has been cranked for more than a total of 60 seconds without allowing sufficient time for the starter to cool. Diagnose all other DTCs and symptoms. Check the charging system voltage and correct as necessary. Clear the DTC. |
| P2535 | Ignition Switch Run/Start Position Circuit High | GO to Pinpoint Test D |
| All DTCs | -- | REFER to: ELECTRONIC ENGINE CONTROLS . |