Pinpoint Test D: Fuel Pump Control Faults
WARNING: This page is about a different variant/trim than selected.
- Normal Operation and Fault Conditions
Refer to the DTC Fault Trigger Conditions.
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition PCM P025A:00 Fuel Pump Module "A" Control Circuit/Open: No Sub Type Information This DTC sets when the PCM detects the FPC circuit is open or shorted to voltage or ground. PCM P025B:00 Fuel Pump Module "A" Control Circuit Range/Performance: No Sub Type Information This DTC sets when the fuel pump control module is still reporting that it is receiving an invalid duty cycle or frequency from the PCM after a calibrated amount of time. Possible Sources
- Fuel pump
- Fuel pump control module
- PCM
- Radio frequency interference or electromagnetic interference
- Wiring, terminals or connectors
- D1 DIAGNOSE THE CONCERN USING THE ENGINE CONTROLS INFORMATION
- Diagnose the concern using the ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID)
Did the diagnosis in Engine Controls instruct to install a new BCM?
Yes INSTALL a new BCM. Refer to Body Control Module (BCM) No The concern was resolved using the ENGINE CONTROLS - PINPOINT TESTS (EXCEPT DIESEL & HYBRID) (1 OF 2) or ENGINE CONTROLS - PINPOINT TESTS (EXCEPT DIESEL & HYBRID) (2 OF 2)