LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Parking Aid System - Vehicles With: Parking Aid Camera) >> Removal And Installation >> Image Processing Module B (IPMB) >> Installation

Image Processing Module B (IPMB): Installation

WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. To install, reverse the removal procedure.
  2. NOTE: This step is only necessary when installing a new component.

    Using a diagnostic scan tool, complete the PMI process for the IPMB following the on-screen instructions.

    Vehicles equipped with front and rear only parking aid camera 

  3. Using a diagnostic scan tool, following the on screen instructions for the LIN New Module Initialization-BCM configure the BCM.

    Vehicles equipped with 360 ° cameras only. 

  4. Using a diagnostic scan tool, following the on screen instructions for the LIN New Module Initialization-IPMB configure the IPMB.
  5. Align the 360 ° cameras. Refer to: 360 Degree View Camera Alignment .

    Vehicles equipped with 360 ° camera and Trailer Reverse Guidance 

  6. Using a diagnostic scan tool, following the on screen instructions for the LIN New Module Initialization-IPMB configure the IPMB.
  7. Align the 360 ° cameras. Refer to: 360 Degree View Camera Alignment .
scientia non olet · About LEMON Manuals