Fuel Tank - Vehicles With: Midship Fuel Tank: Removal
WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Fuel systems will vary in configuration with different wheelbases. Typical application shown.
NOTE:
Removal steps in this procedure may contain installation details.
- Release the fuel system pressure. Refer to: Fuel System Pressure Release .
- Drain the fuel tank. Refer to: Fuel Tank Draining .
-
NOTE: Typical configuration shown in illustration, others similar
Loosen the hose clamps and disconnect the fuel tank filler pipe and vent hose from the fuel filler neck.
Torque: 44 lb.in (5 Nm)
-
NOTE: Typical configuration shown in illustration, others similar
Disconnect the water-in-fuel sensor electrical connector.
-
NOTE: Typical configuration shown in illustration, others similar
Disconnect the 2 fuel line quick release couplings. Refer to: Quick Release Coupling .
-
NOTE: Typical configuration shown in illustration, others similar
Using a transmission jack, support the fuel tank. Remove the fuel tank strap bolts and remove the fuel tank straps. Partially lower the fuel tank for access.
Use the General Equipment: Transmission Jack
Torque: 30 lb.ft (40 Nm)
-
NOTE: Typical configuration shown in illustration, others similar
Disconnect the fuel pump and sender unit electrical connector. Remove the fuel tank.