LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Engine Controls - Fuel Charging And Controls - 6.7L Power Stroke Diesel) >> Removal And Installation >> Fuel Pump Driver Module (FPDM) >> Removal

Fuel Pump Driver Module (FPDM): Removal

WARNING: This page is about a different car, the 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .

    Pickup 

    NOTE: The fuel pump driver module (FPDM) is attached to the top of the frame rear crossmember.
  2. Disconnect the fuel pump driver module (FPDM) electrical connector.
    GFD203487Courtesy of FORD MOTOR COMPANY
  3. Remove the fuel pump driver module (FPDM) retainers and then remove the fuel pump driver module (FPDM).
    GFD203488Courtesy of FORD MOTOR COMPANY

    Chassis Cab 

    NOTE: The fuel pump driver module (FPDM) is attached to the front of the frame rear crossmember.
  4. Disconnect the fuel pump driver module (FPDM) electrical connector.
    GFD203489Courtesy of FORD MOTOR COMPANY
  5. Remove the fuel pump driver module (FPDM) retainers and then remove the fuel pump driver module (FPDM).
GFD203490Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals