DTC P268A - Fuel Injector Calibration Not Learned/Programmed
WARNING: This page is about a different car, the 2020 Ford F-550 Super Duty, 2020 Ford F-450 Super Duty, 2020 Ford F-350 Super Duty, 2020 Ford F-250 Super Duty, and 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
DTC DESCRIPTION P268A - FUEL INJECTOR CALIBRATION NOT LEARNED/PROGRAMMED
| Description: | This DTC sets when the fuel injector energizing time is greater than the permitted energizing time after overrun demand by the driver. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Check for sensor and circuit related DTCs. Reprogram or update the calibration. Check for other DTCs or drive symptoms for further action. Make sure to check for aftermarket performance products before installing a new PCM. If installing a new PCM, refer to FLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) . | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. | ||