DTC P0116 - Engine Coolant Temperature (ECT) Sensor Circuit Range/Performance
WARNING: This page is about a different car, the 2020 Ford F-550 Super Duty, 2020 Ford F-450 Super Duty, 2020 Ford F-350 Super Duty, 2020 Ford F-250 Super Duty, and 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
DTC DESCRIPTION P0116 - ENGINE COOLANT TEMPERATURE (ECT) SENSOR CIRCUIT RANGE/PERFORMANCE
| Description: | This DTC sets when the engine coolant temperature or cylinder head temperature value is higher than the calibrated value and could prevent one or more on board diagnostic (OBD) monitors from completing. The PCM runs this logic after an engine off and a calibrated soak period (typically 6 hours). This soak period allows the intake air temperature and the engine coolant temperature or cylinder head temperature to stabilize and not differ by greater than a calibrated value. This DTC sets when all of the following conditions are met: The engine coolant temperature at engine start exceeds the intake air temperature at engine start by greater than a calibrated value, typically 17°C (30°F). The engine coolant temperature exceeds a calibrated value, typically 107°C (225°F). The fuel system, heated oxygen and misfire monitors have not completed. The calibrated time to set this DTC has expired. |
||
| Possible Causes: |
|
||
| Diagnostic Aids: | Make sure the intake air temperature and the engine coolant temperature or cylinder head temperature are similar when the engine is cold. Also make sure the ECT or CHT sensor and the actual engine operating temperatures are the same. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to PINPOINT TEST K . | ||