LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 745 (Abs Guided Routine - Pinpoint Tests B - BZ) >> Pinpoint Tests BP: Abs Module Communication Concern With The GWM >> Normal Operation And Fault Conditions

Normal Operation And Fault Conditions

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2021 Lincoln Corsair, 2021 Ford Transit-350 HD, 2021 Ford Transit-350, 2021 Ford Transit-250, and 2021 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.

With the ignition ON, the GWM sends messages to the ABS module over the HS-CAN 2. If the ABS module does not receive these messages within a certain time frame (usually less than 1 second), the ABS module sets DTCs. This can be due to a GWM failure, a circuit failure on the HS-CAN or an excessive load on the network. For information on the messages sent to the ABS module by the GWM, refer to the Network Message Chart in Description and Operation of the  Anti-Lock Brake System (ABS) and Stability Control  article. 

PPT BP ABS MODULE DTC FAULT TRIGGER CONDITIONS

DTC Description Fault Trigger Conditions
U0146:00 Lost Communication With Gateway 'A': No Sub Type Information This DTC sets in the ABS module if the GSM message from the GWM is missing for more than the allotted time.