Normal Operation And Fault Conditions
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2021 Lincoln Corsair, 2021 Ford Transit-350 HD, 2021 Ford Transit-350, 2021 Ford Transit-250, and 2021 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.
When the driver presses the clutch pedal, the clutch pedal switch sends a signal to the PCM indicating the pedal has been pressed. The PCM sends a clutch pedal message to the GWM over the HS-CAN1. The GWM sends this message to the ABS module over the HS-CAN2. The ABS module monitors the clutch pedal message and vehicle speed. If the information indicates a concern with the clutch pedal, this DTC is set.
PPT BO ABS MODULE DTC FAULT TRIGGER CONDITIONS
| DTC | Description | PPT AC ABS Module DTC Fault Trigger Conditions |
|---|---|---|
| C1A41:64 | Clutch Pedal Sensor: Signal Plausibility Failure | This DTC sets under a specific driving condition; if the vehicle is moving less than 3 km/h (2 mph) and after vehicle speed is greater than 80 km/h (49 mph) in the same ignition cycle, a clutch pedal signal change is expected to occur. If the clutch pedal signal change does not occur for 5 times, this DTC sets. |