LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 745 (Abs Guided Routine - Pinpoint Tests B - BZ) >> Pinpoint Tests BH: Abs Module Communication Concern With The RCM >> Normal Operation And Fault Conditions

Normal Operation And Fault Conditions

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2021 Lincoln Corsair, 2021 Ford Transit-350 HD, 2021 Ford Transit-350, 2021 Ford Transit-250, and 2021 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.

With the ignition ON, the RCM sends messages to the ABS module over the HS-CAN 2. If the ABS module does not receive these messages within a certain time frame, the ABS module sets a DTCs. For information on the messages sent to the ABS module by the RCM, refer to the Description and Operation in the Anti-Lock Brake System (ABS) and Stability Control article.

PPT BH ABS MODULE DTC FAULT TRIGGER CONDITIONS

DTC Description Fault Trigger Conditions
U0151:00 Lost Communication With Restraints Control Module: No Sub Type Information This DTC sets if any one of the following messages is missing; yaw rate, lateral acceleration, longitudinal acceleration, roll rate or RCM status.
U0452:00 Invalid Data Received From Restraints Control Module: No Sub Type Information Sets if the ABS module receives invalid longitudinal acceleration data from the RCM. This can be due to an incorrectly installed RCM, an RCM that has not been initialized, or an internal failure of the sensor.