LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 745 (Abs Guided Routine - Pinpoint Tests B - BZ) >> Pinpoint Tests BB: SASM Communication Concern With IPC >> Normal Operation And Fault Conditions

Normal Operation And Fault Conditions

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2021 Lincoln Corsair, 2021 Ford Transit-350 HD, 2021 Ford Transit-350, 2021 Ford Transit-250, and 2021 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.

With the ignition ON, the IPC sends messages to the SASM through the GWM and over the HS-CAN 3. If the SASM does not receive these messages within a certain time frame (usually less than 1 second), the SASM sets DTCs. For information on the messages sent to the SASM by the IPC, refer to the Network Message Chart in Description and Operation of the  Anti-Lock Brake System (ABS) and Stability Control  article. 

PPT BB SASM DTC FAULT TRIGGER CONDITIONS

DTC Description Fault Trigger Conditions
U0155:00 Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information Sets in continuous memory and on-demand when the SASM detects any of the IPC messages are missing. This can be due to a IPC failure, a circuit failure on the HS-CAN or an excessive load on the network.