LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Transit Connect Titanium, Gas/Ethanol >> Repair and Diagnosis >> External Pages >> Different car >> Section 743 (Abs Guided Routine - Pinpoint Tests A - AZ) >> Pinpoint Tests AQ: Cruise Control Braking Fault >> Normal Operation And Fault Conditions

Normal Operation And Fault Conditions

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2021 Lincoln Corsair, 2021 Ford Transit-350 HD, 2021 Ford Transit-350, 2021 Ford Transit-250, and 2021 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.

With the ignition ON, the CCM sends messages to the IPMA over a private CAN. 

The IPMA then sends these messages to the ABS module over the HS-CAN 2. If the ABS module does not receive these messages within a certain time frame, the ABS module sets a DTC. For information on the messages sent to the ABS module by the CCM, refer to the Network Message Chart in Description and Operation of the  Anti-Lock Brake System (ABS) and Stability Control  article. 

PPT AQ ABS MODULE DTC FAULT TRIGGER CONDITIONS

DTC Description Fault Trigger Conditions
U2107:68 Collision Mitigation By Braking: Event Information Sets when the ABS module detects the vehicle deceleration is implausibly high when compared to the vehicle deceleration requested by the CCM. This is most likely caused by an abrupt stop of the vehicle due to a collision, an extreme driving situation, a mechanical or electrical failure of the cruise control system or an internal failure of the ABS module.